![]() ![]() An individual branch circuit will have its own receptacle load line, neutral line, and ground line. Verify the wall outlets do not share neutral wiring and that each wall outlet is on an individual branch circuit.More importantly, a non-dedicated branch circuit may constitute a safety hazard to the treadmill operator. circuit providing the treadmill power is found to be a non-dedicated branch circuit or a circuit equipped with a capacity of less than 20 amps, the AC circuit must be corrected before any reliable Troubleshooting can be performed. IMPORTANT: If the AC Alternating Current: electric current which periodically reverses direction between positive and negative polarity. If YES, advise the customer to have the facility wiring upgraded to provide one individual branch circuit outlet per machine, see Precor specifications, see.If more than one treadmill loses power, the treadmills are on the same breaker: To verify if multiple treadmills are sharing the same wall breaker, manually switched OFF the facility outlet circuit breaker. This will be especially evident if two or more treadmills shutdown at the same time. Verify whether there is more than one treadmill using the same outlet circuit breaker.If the line cord is not damaged continue with the following steps. If there is power at the wall outlet, inspect the power cord, if damaged, replace the line cord.If the is approximately 0 Vac voltage in an alternating current circuit, the wall breaker has tripped. Measure the facility wall outlet voltage.If the facility outlet circuit breaker trips After the exerciser walks onto the belt.After the belt starts but before the exerciser walks onto the belt.It is also extremely important to know when the breaker trip occurs, note which one of the following events best describes when the circuit breaker tripped: It is extremely important to know whether the tripped circuit breaker is the treadmill ON/OFF circuit breaker or the facility wall outlet circuit breaker. Review the electrical requirements, see Power Requirements and Power Entry Assembly Wire Diagram. Troubleshooting a tripped treadmill ON/OFF circuit breaker or facility power distribution panel circuit breaker. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |